Maretron TLA100 User Manual

®® Revision 1.3 Page i TLA100 Tank Level Adapter User’s Manual Revision 1.3 Copyright © 2012 Maretron, LLP All Rights

TLA100 User’s Manual 2.3.2 Connecting to NMEA 2000® Interface The Maretron TLA100 provides a connection to an NMEA 2000® interface through a five

®® Revision 1.3 Page 7 3.1 Configuring Tank Type As shipped from the factory, the TLA100 transmits the tank type as “Fuel. You can reconfigur

TLA100 User’s Manual Page 8 Revision 1.3 need an ohmmeter to make the two resistive measurements, which are 1) power terminal to sensor te

®® Revision 1.3 Page 9 3.4 Configuring Tank Capacity In addition to indicating the fluid level within a tank, the TLA100 also has the ability

TLA100 User’s Manual Page 10 Revision 1.3 • Check the security of the cables connected to the NMEA 2000® interface and the connections to

®® Revision 1.3 Page 11 Symptom Troubleshooting Procedure analog gauge resistive values have been configured or programmed into the TLA100 (se

TLA100 User’s Manual Page 12 Revision 1.3 Mechanical Parameter Value Comment Size 3.9”” x 1.2” x 1.0” Excluding NMEA 2000® Connector &

®® Revision 1.3 Page 13 8 Maretron (2 Year) Limited Warranty Maretron warrants the TLA100 to be free from defects in materials and workmanshi

TLA100 User’s Manual Page 14 Revision 1.3 This page intentionally left blank.

®® Revision 1.3 Appendix A – NMEA 2000® Interfacing Page A1 Appendix A – NMEA 2000® Interfacing TLA100 NMEA 2000® Periodic Data Transmitted PGN

TLA100 User’s Manual Page ii Revision 1.3 Revision History Revision Description 1.0 Original document 1.1 Minor Updates 1.2 Corrected de

®® Revision 1.3 Page iii Table of Contents 1 General ...

TLA100 User’s Manual Page iv Revision 1.3 Table of Figures Figure 1– Mounting Location When Used with Analog Gauge ...

®® Revision 1.3 Page 1 1 General 1.1 Introduction Congratulations on your purchase of the Maretron Tank Level Adapter (TLA100). Maretron has d

TLA100 User’s Manual Page 2 Revision 1.3 1.4 Quick Install Installing the Maretron TLA100 involves the following steps. Please refer to th

®® directly connected to the gauge without any splices (see Figure 1). You may also consider placing the TLA100 as close as possible to the NMEA 2000

TLA100 User’s Manual Figure 2 – Mounting Location When Used Without Analog Gauge 2.3 Connecting the TLA100 There are two connection points (see

®® 2.3.1 Connecting Attached Gray Cable to Analog Gauge or Tank Sender The TLA100 can be used together with an analog gauge(s) (referred to as NMEA 2